Hello,
Having some difficulties reaching my regional UHF relay in Lille, I decided to build a cubical quad antenna. Why not a Yagi-Uda? Because the quad has an impedence of 50 Ohms! No need to build a matching system. So I went looking for a cubical quad calculator:
http://www.csgnetwork.com/antennae5q2calc.html (http://www.csgnetwork.com/antennae5q2calc.html)
Here are the results:
(http://radiopreppers.com/images/quad.png)
I thought of an original way to build it, unlike anything I have seen before... You'll just have to wait to see the design, but here is a picture to get your imagination going ;)
(http://radiopreppers.com/images/quadb1.jpg)
Gil.
This photo should make things easier to picture...
(http://radiopreppers.com/images/quadb2.jpg)
Gil.
Eagerly waiting for your next pics. :)
Here is the last one for tonight. Only the reflector is glued in place. The three other elements are only there for the photo. I do not know if reflector and directors placement affect SWR so I did not want to commit to the calculator's results right away. Anyone knows? I have a VHF/UHF SWR meter on order... Still missing three aluminum rods since this is a seven-element quad! I also have an N-type female connector ready, along with an N-to-SMA_male cable.
The aluminum rods will be soldered end-to-end using a drop of vaseline as flux. I read about this trick on a French amateur radio site. I was going to say "a French Ham site," but it sounded too much like some dish ::) The driven element is copper. I left a one-centimeter gap on one side for feeding.
The vertical sticks you see in the middle ensure correct element placement since the squares are of decreasing size. I hope the whole shebang doesn't require millimeter-precision. I am close, but it won't be perfect. There are too many variables to get everything perfect by hand.
I think after setting everything up properly I might close the box. It would make it much stronger and look like, well, a box... It won't be an antenna to use on top of a mast, but a portable one.
(http://radiopreppers.com/images/quadb3.jpg)
Gil.
Fascinating. Love your woodwork! 7 elements should get you out there.
My Arrow hand held satellite Yagi is a nice 50 Ohms, but it does have that gamma match that has a lot of drawbacks. Mainly it's hard to make it water tight and weather proof.
Can't wait to see your final product!
Thanks. I need to wait for the SWR meter I ordered to go any further...
Gil